WattsInaName
I'm guessing since there was not much air inside the space between the roof and the mdf, that it pulled the sheet metal down since it was the most pliable. Just sucks after all the work I've done, I now have to figure out a way to un-adhere the foam from the roof without taking the mdf out? Any thoughts?

Quote 0 0
Master Yoda
you can get a slide hammer and pull the dent out. or you can just do several cats of bondo till it is shaped write again? good luck!!
Quote 0 0
D-Bass
bondo for bodywork, never thicker than a dime is the rule
Quote 0 0
Rob Tabor
150+ SPL at 25-35 HZ for 30 Seconds Should Do the Trick
Quote 0 0
Mr. Slate
If thats not your daily driver, I wouldn't worry about it too much.
Quote 0 0
Contact Us | Legal Notices | Privacy