Dinoman
2 PF600s strapped

or

2 D9s Strapped

or

1 CS pf9K
Quote 0 0
AudioXtremes
I'm going to guess the cs 9k
Quote 0 0
Master Yoda
well there are ceveral things to concider on the choices!!
1. What are you using the amp for? (bass race or burps)
2. what voltage are you running?
3. what is the ohm load to be strapped at?
4. what is the cone rise?
5. what HZ are you burping at?

There are many factors to conider when choicing an amp for power one major thing is effiency!!
some times it is better to runn a bigger amp at a higher ohm load then to run two smaller amps at a low impedance!! depending on your battery bank? I know that this is not a whole lot of help but should get you asking the rigth questions? good luck
Quote 0 0
Dinoman
I was hoping I wouldnt have to do this but okay . at 16 volts .25ohm. less than .67 rise.65 hz in a crx
Quote 0 0
Master Yoda
then you would be better of with the Cactus 9ks it is the 16 volt amp the regular 9k is an 18 volt amp. both do the same power one just dose it at a lower voltage!! good luck
Quote 0 0
Dinoman
Thanks
Quote 0 0
integra spl
it think the better solution is a couple of d9s
Quote 0 0
stewie
how about a CS ELT 12 with 16 volts it hides nice in a crx and will do a nice amount of power
Quote 0 0
Dinoman
Thanks Stewie ,Unforunatly I think the 9 and the 12 are a little out of myprice range , I may have to get rid of my 2 pf600s in order to be able get the 9 or 12 from cactus
Quote 0 0
Cactus Sounds
How about getting 2 more PF 600? hehe
Quote 0 0
Cactus Sounds
How about getting 2 more PF 600.1?
Hehe
Quote 0 0
stewie
that sounds like a good plan too 4 600.1 then he will have fun hiding them all
Quote 0 0
Cactus Sounds
lol....
Quote 0 0
Dinoman
In the box ??
Quote 0 0
Cactus Sounds
lol....
Quote 0 0
Contact Us | Legal Notices | Privacy